Fiber Optic LED Driver

It is a Easy make Electronic Circuit Project of Fiber optic led driver Circuit. The pull-up transistor of the totem-pole output is used-to turn on the LED and the pull-down transistor is used to turn ·off the LED. The lower impedance and higher current handling capability of the saturated pull-down transistor is used as an effective method of transferring the charge from the LED`s anode to ground as its dynamic resistance increases during turn-off. The slightly higher output impedance of the pull-up stage ensures that the LED is not over peaked during the less difficult turn-on transition.

Fiber Optic LED Driver Circuit Diagram:

LED Driver Circuit Diagram

This asymmetric current handling capability of the output stage with its variable impedance substantially reduces the pulse-width distortion and long-tai)ed response. As the signal propagates through two NAND gates, each transition passes through the high-to-low and low-to-high transition once, normalizing the total propagation delay through the circuit.




Share this article

0 comments:

Post a Comment

 
Copyright © 2016 W3circuits.com • All Rights Reserved.
back to top