Active Audio System Use three TDA2052

This active audio audio system use three TDA2052 chips and 5 speakers ( one woofer, two tweeters and two midranges ) .For this TDA2052 active audio system we need dual 20 volts power supply and five volts supply for the stand by function.To the input of the every audio IC chip is placed an audio filter for filtering the audio signal for used speakers ( low pass for woofer , high pass for midranges and tweeters )

Active Audio System Circuit Diagram


The subwoofer plays the 20 to 300 Hz frequency range, while the remaining 300 Hz to 20KHz are sent to two separate channels with stereo effect.If one of the amplifier is affected by clipping distortion the others amplifiers are not affected .
Share this article

0 comments:

Post a Comment

 
Copyright © 2016 W3circuits.com • All Rights Reserved.
back to top